Home › Vehicle Interior › DOOR LOCK › KEY REMINDER WARNING SYSTEM (w/o Entry and Start System)

KEY REMINDER WARNING SYSTEM (w/o Entry and Start System) > DATA LIST / ACTIVE TEST

for Preparation Click here



READ DATA LIST

NOTICE:
In the following table, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.

HINT:
Using the GTS to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.

  1. Turn the ignition switch off.

  2. Connect the GTS to the DLC3.

  3. Turn the ignition switch to ON.

  4. Turn the GTS on.

  5. Enter the following menus: Body Electrical / Main Body / Data List.

  6. Read the Data List according to the display on the GTS.

    Main Body 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    IG SW
    Ignition switch on signal / OFF or ON
    OFF: Ignition switch off
    ON: Ignition switch ON
    -
    ACC SW
    Ignition switch ACC signal / OFF or ON
    OFF: Ignition switch off
    ON: Ignition switch ACC
    -
    Key Unlock Warning SW
    Unlock warning switch / OFF or ON
    OFF: Ignition key is not inserted
    ON: Ignition key is inserted
    -
    D Door Courtesy SW
    Driver side door courtesy light switch signal / ON or OFF
    ON: Driver side door opened
    OFF: Driver side door closed
    -