AUDIO AND VISUAL SYSTEM > Radio Receiver Power Source Circuit |

| 1.CHECK HARNESS AND CONNECTOR (RADIO RECEIVER ASSEMBLY - BATTERY, BODY GROUND) |
Disconnect the radio receiver assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| D14-7 (GND1) - Body ground | Always | Below 1 Ω |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| D14-4 (+B1) - D14-7 (GND1) | Always | 11 to 14 V |
| D14-3 (ACC1) - D14-7 (GND1) | Ignition switch ACC | 11 to 14 V |
|
| ||||
| OK | ||
| ||