Home › Audio / Visual / Telematics › AUDIO / VIDEO › AUDIO AND VISUAL SYSTEM

AUDIO AND VISUAL SYSTEM > Radio Broadcast cannot be Received or Poor Reception

for Preparation Click here


INSPECTION PROCEDURE

1.CHECK RADIO RECEIVER ASSEMBLY
  1. Check the radio automatic station search function.

    1. Check the radio automatic station search function by activating it.

      Result:
      Result
      Proceed to
      Automatic station search function does not stop
      A
      Automatic station search function stops on a station
      B



B
REPLACE RADIO RECEIVER ASSEMBLY
A


2.CHECK OPTIONAL COMPONENTS
  1. Check if the telephone antenna or other optional components are installed.

    Result:
    Result
    Proceed to
    Optional components are not installed
    A
    Optional components are installed
    B

    NOTICE:
    Do not remove optional components without the permission of the customer.



B
REMOVE OPTIONAL COMPONENTS AND CHECK AGAIN (SEE NOTICE ABOVE)
A


3.CHECK RADIO RECEIVER ASSEMBLY


    E187251
  1. Preparation for check

    1. Remove the antenna connector from the radio receiver assembly.

  1. Check for noise

    1. Turn the ignition switch ACC with the radio receiver assembly connector connected.

    2. Turn the radio on and tune into AM mode.

    3. Place a screwdriver, thin wire or other metal object on the radio receiver assembly antenna jack and check that noise can be heard from the speakers.

      OK:
      Noise can be heard from the speakers.



NG
REPLACE RADIO RECEIVER ASSEMBLY
OK


4.INSPECT RADIO RECEIVER ASSEMBLY
  1. Disconnect the radio receiver assembly connector.



    E188455E29
  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    RA-5 (ANT+) - Body ground
    Ignition switch ACC
    Radio switch on and FM or AM selected
    11 to 14 V

    Text in Illustration 
    *a
    Component without harness connected
    (Radio Receiver Assembly)



NG
REPLACE RADIO RECEIVER ASSEMBLY
OK


5.REPLACE ANTENNA CORD SUB-ASSEMBLY
  1. Replace the antenna cord sub-assembly and check if radio broadcasts can be received normally .

    OK:
    Radio broadcasts can be received normally.



NG
Go to step 6
OK

NORMAL OPERATION 

6.CHECK NO. 2 ANTENNA CORD SUB-ASSEMBLY
  1. Disconnect the No. 2 antenna cord sub-assembly.

  1. Measure the resistance the No. 2 antenna cord sub-assembly to check for an open circuit in the No. 2 antenna cord sub-assembly.

    Standard Resistance:
    Below 1 Ω

  1. Measure the resistance between the No. 2 antenna cord sub-assembly and body ground to check for a short circuit in the No. 2 antenna cord sub-assembly.

    Standard Resistance:
    10 kΩ or higher



NG
REPLACE NO. 2 ANTENNA CORD SUB-ASSEMBLY
OK


7.REPLACE AMPLIFIER ANTENNA ASSEMBLY
  1. Replace the amplifier antenna assembly and check if radio broadcasts can be received normally.

    OK:
    Radio broadcasts can be received normally.



NG
REPLACE RADIO RECEIVER ASSEMBLY
OK

NORMAL OPERATION