Home › Vehicle Interior › SEAT › SEAT HEATER SWITCH

SEAT HEATER SWITCH > INSPECTION

for Preparation Click here



1. INSPECT SEAT HEATER SWITCH (for LH)


  1. Check the seat heater switch.



      B314994E01
    1. Measure the resistance according to the value(s) in the table below.
      Text in Illustration 
      *a
      Component without harness connected
      (Seat Heater Switch (for LH))

      Standard Resistance:
      Tester Connection
      Switch Condition
      Specified Condition
      1 - 2
      ON (HI)
      Below 1 Ω
      3 - 4
      ON (HI)
      Below 1 Ω
      2 - 4
      ON (LO)
      Below 1 Ω

      If the result is not as specified, replace the seat heater switch (for LH).



  1. Check that the indicator illuminates.



      B314994E01
    1. Apply battery voltage to the seat heater switch (for LH) and check that the indicator illuminates.
      Text in Illustration 
      *a
      Component without harness connected
      (Seat Heater Switch (for LH))

      OK:
      Condition
      Switch Condition
      Specified Condition
      Battery positive (+) → Terminal 2
      Battery negative (-) → Terminal 3
      ON (HI)
      Indicator illuminates
      Battery positive (+) → Terminal 2
      Battery negative (-) → Terminal 3
      ON (LO)

      If the result is not as specified, replace the seat heater switch (for LH).



2. INSPECT SEAT HEATER SWITCH (for RH)


  1. Check the seat heater switch.



      B314993E01
    1. Measure the resistance according to the value(s) in the table below.
      Text in Illustration 
      *a
      Component without harness connected
      (Seat Heater Switch (for RH))

      Standard Resistance:
      Tester Connection
      Switch Condition
      Specified Condition
      1 - 2
      ON (HI)
      Below 1 Ω
      3 - 4
      ON (HI)
      Below 1 Ω
      2 - 4
      ON (LO)
      Below 1 Ω

      If the result is not as specified, replace the seat heater switch (for RH).



  1. Check that the indicator illuminates.



      B314993E01
    1. Apply battery voltage to the seat heater switch (for RH) and check that the indicator illuminates.
      Text in Illustration 
      *a
      Component without harness connected
      (Seat Heater Switch (for RH))

      OK:
      Condition
      Switch Condition
      Specified Condition
      Battery positive (+) → Terminal 2
      Battery negative (-) → Terminal 3
      ON (HI)
      Indicator illuminates
      Battery positive (+) → Terminal 2
      Battery negative (-) → Terminal 3
      ON (LO)

      If the result is not as specified, replace the seat heater switch (for RH).