Home › Vehicle Interior › SEAT BELT › SEAT BELT WARNING SYSTEM

SEAT BELT WARNING SYSTEM > TERMINALS OF ECU

for Preparation Click here



CHECK COMBINATION METER ASSEMBLY


  1. Disconnect the D7 combination meter assembly connector.


    B129553E11

  2. Measure the resistance and voltage according to the value(s) in the table below.

    HINT:
    Measure the values on the wire harness side with the connector disconnected.


    Tester Connection
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    D7-1 (B) - Body ground
    R-W - Body ground
    Combination meter +B line
    Always
    11 to 14 V
    D7-2 (IG+) - Body ground
    W-G - Body ground
    Combination meter IG line
    Ignition switch ON
    11 to 14 V
    Ignition switch off
    Below 1 V
    D7-20 (ES1) - Body ground
    B-Y - Body ground
    Ground
    Always
    Below 1 Ω
    D7-37 (DBKL) - Body ground
    R-B - Body ground
    Driver seat belt signal
    Driver seat belt fastened
    10 kΩ or higher
    Driver seat belt unfastened
    Below 1 Ω
    D7-38 (PBKL) - Body ground
    R-G - Body ground
    Front passenger seat belt signal
    Front passenger seat occupied, seat belt fastened
    10 kΩ or higher
    Front passenger seat occupied, seat belt unfastened
    Below 1 Ω
    D7-40 (ES2) - Body ground
    B-Y - Body ground
    Ground
    Always
    Below 1 Ω
    If the result is not as specified, there may be a malfunction in the wire harness.

  3. Reconnect the D7 combination meter assembly connector.

  4. Measure the voltage according to the value(s) in the table below.

    Tester Connection
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    D7-13 (P/SB) - Body ground
    BR-R - Body ground
    Front passenger seat belt warning signal
    Front passenger seat occupied, seat belt fastened
    Below 1 V
    Front passenger seat occupied, seat belt unfastened
    11 to 14 V
    If the result is not as specified, the combination meter assembly may have a malfunction.