Home › Suspension › TIRE / WHEEL › TIRE AND WHEEL SYSTEM

TIRE AND WHEEL SYSTEM > INSPECTION

for Preparation Click here



1. INSPECT TIRES
  1. Check the tires for wear and proper inflation pressure.

    Cold Tire Inflation Pressure:

    Tire Size
    Front
    kPa (kgf/cm2, psi)
    Rear
    kPa (kgf/cm2, psi)
    205/55R16 91V
    240 (2.4, 35)
    240 (2.4, 35)
    215/45R17 87W
    240 (2.4, 35)
    240 (2.4, 35)
    T135/80D 16 101M
    420 (4.2, 60)
    420 (4.2, 60)



    C265375
  1. Using a dial indicator, check the runout of the wheel.
    Maximum wheel runout 
    Steel wheel
    2.0 mm (0.0787 in.) (Vertical and lateral)
    Aluminum wheel
    1.0 mm (0.0394 in.) (Vertical and lateral)



2. ROTATE TIRES


    C224078
  1. Rotate the tires as shown in the illustration.
    Text in Illustration 
    V100135
    Front of the Vehicle

    Torque:
    120 N*m{ 1224 kgf*cm , 89 ft.*lbf }



3. INSPECT WHEEL BALANCE
  1. Check and perform off-car balancing.

  1. If required, perform on-car balancing.

    Imbalance after adjustment:
    10.0 g (0.0220 lb) or less



4. INSPECT FRONT AXLE HUB BEARING LOOSENESS



5. INSPECT REAR AXLE HUB BEARING LOOSENESS



6. INSPECT FRONT AXLE HUB RUNOUT



7. INSPECT REAR AXLE HUB RUNOUT