Home › Vehicle Interior › LIGHTING (INT) › PERSONAL LIGHT

PERSONAL LIGHT > INSPECTION

for Preparation Click here



1. INSPECT MAP LIGHT ASSEMBLY


E247992E01
  1. Check the map light assembly operation.

    1. Apply battery voltage to the terminals and check that the light comes on.
      OK: 
      Condition
      Switch Condition
      Specified Condition
      Battery positive (+) - 2 (+B)
      Battery negative (-) - 1 (GND)
      Map light switch ON
      Map light comes on
      Battery positive (+) - 2 (+B)
      Battery negative (-) - 3 (DOOR SW)
      Map light switch DOOR
      Map light comes on
      If the result is not specified, replace the map light bulb or map light assembly.
      Text in Illustration 
      *a
      Component without harness connected
      (Map Light Assembly)