Home › Drivetrain · TL70 MANUAL TRANSMISSION / TRANSAXLE › NEUTRAL POSITION SWITCH

NEUTRAL POSITION SWITCH > INSPECTION

for Preparation Click here



1. INSPECT NEUTRAL POSITION SWITCH ASSEMBLY


    C251380E01
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    1 - 2
    Pushed
    10 kΩ or higher
    1 - 2
    Released
    Below 1 Ω

    Text in Illustration 
    *a
    Component without harness connected
    (Neutral Position Switch Assembly)
    If the result is not as specified, replace the neutral position switch assembly.