Home › Power Source / Network › FA20 BATTERY / CHARGING › GENERATOR

GENERATOR > DISASSEMBLY

for Preparation Click here



1. REMOVE GENERATOR REAR END COVER


    A277202
  1. Remove the 4 through bolts.



    A279034E01
  1. Using the heat gun, heat the generator rear end cover.

    Heating Temperature:
    Item
    Temperature
    Generator Rear End Cover
    50 to 60°C (122 to 140°F)

    Text in Illustration 
    *1
    Heat gun



    A277228
  1. Insert the 2 screw drivers, and remove the generator rear end cover as shown in the illustration.



2. REMOVE GENERATOR PULLEY


    A277204E01
  1. Mount the generator in a vise between aluminum plates.
    Text in Illustration 
    *1
    Aluminium plate



    A277205
  1. Remove the nut and generator pulley.



3. REMOVE GENERATOR DRIVE END FRAME ASSEMBLY


    A277206
  1. Remove the generator drive end frame assembly from the generator rotor assembly.



4. REMOVE GENERATOR DRIVE END FRAME BEARING


    A277207E01
  1. Mount the generator drive end frame assembly in a vise between aluminum plates.

  1. Remove the 4 bolts and bearing retainer.
    Text in Illustration 
    *1
    Aluminium plate



    A153386E04
  1. Using SST and a hammer, tap out the bearing.

    SST
    09950-60010   (09951-00250)
    09950-70010   (09951-07100)



5. REMOVE GENERATOR ROTOR BEARING


    A279035E01
  1. Set the SST to the generator rotor assembly between wooden blocks.

    SST
    09387-00041  
    Text in Illustration 
    *1
    Wooden block



    A279036E01
  1. Hold the SST nut, and turn the SST bolt to remove the generator rotor bearing.
    Text in Illustration 
    *1
    SST Nut
    *2
    SST Bolt
    *a
    Hold
    *b
    Turn



6. REMOVE GENERATOR COIL ASSEMBLY


    A277213
  1. Remove the 6 bolts and generator coil assembly.



7. REMOVE GENERATOR BRUSH HOLDER ASSEMBLY


    A277214
  1. Remove the 4 bolts and generator brush holder assembly.



8. REMOVE BRUSH


    A277215
  1. Remove the cover A from the brush holder assembly.



    A277216
  1. Remove the cover B from the brush holder assembly.



    A277217E01
  1. Using a soldering iron, separate the 2 brushes from the brush holder assembly.
    Text in Illustration 
    *1
    Soldering iron



9. REMOVE GENERATOR HOLDER WITH RECTIFIER


    A277218
  1. Remove the terminal cover.



    A277219
  1. Remove the nut and the terminal.



    A277220
  1. Remove the 3 bolts and the generator holder with rectifier.