Home › Drivetrain ยท TX6A AUTOMATIC TRANSMISSION / TRANSAXLE › SHIFT LEVER

SHIFT LEVER > DISASSEMBLY

for Preparation Click here



1. REMOVE FLOOR SHIFT SHIFT LEVER HOUSING


    C260593
  1. Using a screw driver, disengage the claw and disconnect the connector.



    C261653
  1. Using a thin-bladed screwdriver, lift up the terminal retainer of the transmission control switch connector to release the lock.



    C260594
  1. Using a thin-bladed screwdriver, pull out terminals 2, 3, 10 and 11 of the transmission control switch connector.



    C260595
  1. Remove the shift lever lock nut and shift lever lock pin.



    C260596
  1. Disengage the 2 claws and remove the floor shift shift lever housing from the base plate.



2. REMOVE SHIFT LOCK CONTROL UNIT ASSEMBLY


C260600
  1. Remove the pin then remove the shift lock release arm and shift lock control unit assembly.

  1. Remove the shift lock release arm from the shift lock control unit assembly.



3. REMOVE DETENT ROD


C262067
  1. Remove the detent lock clamp.

  1. Remove the detent lock spring and detent lock rod.

  1. Remove the cushion detent lock from the detent lock rod.

  1. Remove the bush detent lock.



4. REMOVE SHIFT LEVER PLATE GROMMET


    C260605
  1. Remove the shift lever plate grommet from the base plate.



5. REMOVE FLOOR SHIFT CONTROL SHAFT LEVER


    C260602
  1. Using a pin punch (3 mm (0.118 in.)) and a hammer, drive out the spring pin.



    C261899
  1. Remove the floor shift control shaft lever from the base plate.



6. REMOVE FLOOR SHIFT CONTROL SELECT LEVER


    C261900
  1. Remove the floor shift support bracket and the floor shift control shaft lever from the base plate.



7. REMOVE FLOOR SHIFT SUPPORT BRACKET


    C261901
  1. Remove the floor shift support bracket from the floor shift control shaft lever.



    C262079
  1. Remove the pin and the spring from the floor shift support bracket.



8. REMOVE SHIFT LEVER SEAT SUB-ASSEMBLY


    C260606
  1. Remove the 4 spacer plates and shift lever seat sub-assembly from the base plate.



9. REMOVE FLOOR SHIFT CONNECTING ROD SWIVEL


    C260604
  1. Remove the clip, 2 washers, grommet, pin and floor shift connecting rod swivel from the select lever.