Home › Drivetrain ยท CLUTCH › CLUTCH MASTER CYLINDER (for LHD)

CLUTCH MASTER CYLINDER (for LHD) > REMOVAL

for Preparation Click here



1. DRAIN CLUTCH FLUID

NOTICE:
Immediately wash off any clutch fluid that comes into contact with any painted surfaces.

HINT:
If any work is done on the clutch system or if air in the clutch lines is suspected, bleed the air from the system.



2. REMOVE INSTRUMENT SIDE PANEL LH (w/o Knee Airbag)

HINT:
Use the same procedure as for the RH side.



3. REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (w/o Knee Airbag)


    B312955
  1. Remove the 2 screws.



    B312956
  1. Disengage the 4 clips.

  1. Disengage the 4 claws and separate the No. 1 instrument panel under cover sub-assembly.



    B313000E01
  1. w/ Automatic Air Conditioning System for RHD:

    1. Disengage the guide and disconnect the aspirator hose.

    2. Disconnect the connector.

  1. Disconnect each connector and remove the No. 1 instrument panel under cover sub-assembly.
    Text in Illustration 
    *1
    Aspirator Hose



4. REMOVE LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY (w/ Knee Airbag)
(Click here)


5. REMOVE CLUTCH MASTER CYLINDER PUSH ROD CLEVIS


    C263939
  1. Remove the clip and the clevis pin, and separate the clutch master cylinder push rod clevis from the clutch pedal lever sub-assembly.



6. REMOVE FRONT SUSPENSION UPPER TO COWL BRACE SUB-ASSEMBLY LH
(Click here)


7. REMOVE CLUTCH MASTER CYLINDER ASSEMBLY


    C258503
  1. Remove the union bolt, 2 gaskets and the master cylinder to the release cylinder hose from the clutch release cylinder assembly.

    HINT:
    Use a container to collect the fluid.



    C262633
  1. Remove the 2 nuts and the clutch master cylinder assembly and sheet.



8. REMOVE CLUTCH MASTER CYLINDER TO FLEXIBLE HOSE TUBE


C262744
  1. Using a union nut wrench (10 mm), disconnect the clutch master cylinder to flexible hose tube from the master cylinder to release cylinder hose.

    HINT:
    Use a container to collect the fluid.

  1. Remove the clip and the clutch flexible hose bracket.

  1. Using a union nut wrench (10 mm), remove the clutch master cylinder to flexible hose tube from the clutch master cylinder assembly.

    HINT:
    Use a container to collect the fluid.