Home › Drivetrain · CLUTCH › CLUTCH PEDAL SWITCH (for RHD)

CLUTCH PEDAL SWITCH (for RHD) > INSPECTION

for Preparation Click here



1. INSPECT CLUTCH START SWITCH ASSEMBLY


    C262733E01
  1. Measure the resistance according to the value(s) in the table below.
    Text in Illustration 
    *a
    9.0 to 10.0 mm (0.354 to 0.394 in.)
    *b
    ON
    *c
    OFF

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    1 - 2
    ON (Pushed in)
    Below 1Ω
    OFF (Released)
    10 kΩ or higher

    If the resistance is not as specified, replace the clutch start switch assembly.



2. INSPECT CLUTCH SWITCH ASSEMBLY


    C262733E01
  1. Measure the resistance according to the value(s) in the table below.
    Text in Illustration 
    *a
    5.0 to 6.5 mm (0.197 to 0.256 in.)
    *b
    ON
    *c
    OFF

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    1 - 2
    ON (Pushed in)
    Below 1Ω
    OFF (Released)
    10 kΩ or higher

    If the resistance is not as specified, replace the clutch switch assembly.