Home › Engine / Hybrid System › FA20 ENGINE CONTROL › VACUUM SENSOR

VACUUM SENSOR > INSTALLATION

for Preparation Click here



1. INSTALL MANIFOLD ABSOLUTE PRESSURE SENSOR
  1. Apply a light coat of engine oil to a new O-ring and install it to the manifold absolute pressure sensor.

  1. Install the manifold absolute pressure sensor with the bolt.

    Torque:
    for Resin Intake Manifold:
    4.0 N*m{ 41 kgf*cm , 35 in.*lbf }
    for Aluminum Intake Manifold:
    3.4 N*m{ 35 kgf*cm , 30 in.*lbf }

    NOTICE:
    1. If a component has been dropped or subjected to a strong impact, replace it.
    2. Make sure that the O-ring is not damaged or does not jump out of position during installation.

  1. Connect the manifold absolute pressure sensor connector.



2. INSTALL NO. 1 ENGINE COVER SUB-ASSEMBLY
for Resin Intake Manifold:



3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL