Home › Engine / Hybrid System › FA20 ENGINE CONTROL › VACUUM SENSOR

VACUUM SENSOR > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL



2. REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY
for Resin Intake Manifold:



3. REMOVE MANIFOLD ABSOLUTE PRESSURE SENSOR


    A391655E01
  1. Disconnect the manifold absolute pressure sensor connector.
    Text in Illustration 
    *A
    for Resin Intake Manifold
    *B
    for Aluminum Intake Manifold



    A391656E01
  1. Remove the bolt and manifold absolute pressure sensor.
    Text in Illustration 
    *A
    for Resin Intake Manifold
    *B
    for Aluminum Intake Manifold



    A276541
  1. Remove the O-ring from the manifold absolute pressure sensor.