Home › Vehicle Exterior › LIGHTING (EXT) › HEADLIGHT LEVELING SWITCH

HEADLIGHT LEVELING SWITCH > INSPECTION

for Preparation Click here



1. INSPECT HEADLIGHT LEVELING SWITCH


E248006E01
  1. Check the ratio.
    Text in Illustration 
    *a
    Component with harness connected
    (Headlight Leveling Switch)

    1. Connect the positive (+) battery lead to terminal 8 (B) and the negative (-) battery lead to terminal 5 (E).

    2. Check the ratio which is obtained by dividing the voltage between terminals 7 (T) and 5 (E) by the voltage between 6 (T) and 5 (E). The voltages must be measured using a voltmeter.

      Standard Ratio:
      Switch Condition
      Specified Condition
      0
      0.84 to 0.89
      1
      0.67 to 0.73
      2
      0.51 to 0.57
      3
      0.36 to 0.41
      4
      0.21 to 0.26
      5
      0.07 to 0.10

      If the result is not as specified, replace the headlight leveling switch.



    E248002E01
  1. Check the operation of the headlight leveling switch illuminates.

    1. Apply battery voltage to the headlight leveling switch illuminates terminals.

      OK:
      Condition
      Specified Condition
      Battery positive (+) → 3
      Battery negative (-) → 2
      Illuminates

      Text in Illustration 
      *a
      Component without harness connected
      (Headlight Leveling Switch)
      If the result is not as specified, replace the headlight leveling switch.