Home › Vehicle Exterior › WIPER / WASHER › WIPER SWITCH

WIPER SWITCH > INSTALLATION

for Preparation Click here


HINT:
  1. Use the same procedure for the LHD and RHD vehicles.
  2. The procedure listed below is for the LHD vehicles.



1. INSTALL WINDSHIELD WIPER SWITCH ASSEMBLY


    B314883
  1. Engage the claw and install the windshield wiper switch assembly as shown in the illustration.

  1. Connect the connector.



2. INSTALL UPPER STEERING COLUMN COVER
  1. Engage the 4 claws and install the upper steering column cover.



3. INSTALL LOWER STEERING COLUMN COVER
  1. w/ Knee Airbag

    1. Engage the 4 claws to install the lower steering column cover.

  1. w/o Knee Airbag

    1. Engage the 6 claws to install the lower steering column cover.

  1. While turning the steering wheel assembly to the right and left, install the 2 screws.



4. INSTALL STEERING COLUMN COVER SUPPORT (w/ Entry and Start System)
  1. Engage the 4 claws and install the steering column cover support.



5. INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (w/o Knee Airbag)
  1. Connect each connector.



    B312545E01
  1. for Automatic Air Conditioning System for RHD:

    1. Connect the connector.

    2. Engage the guide and connect the aspirator hose.
      Text in Illustration 
      *1
      Aspirator Hose

  1. Engage the 4 claws.

  1. Engage the 4 clips to install the No. 1 instrument panel under cover sub-assembly.

  1. Install the 2 screws.



6. INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (w/ Knee Airbag)
  1. Connect each connector.

  1. Engage the 2 claws.

  1. Engage the 6 clips to install the No. 1 instrument panel under cover sub-assembly.

  1. Install the screw.



7. INSTALL UPPER INSTRUMENT PANEL METER ORNAMENT
  1. Connect the connector.

  1. Engage the 2 claws that are holding the upper instrument panel meter ornament and steering column cover together.

  1. Engage the 2 clips and 6 claws.



8. INSTALL METER HOOD SUB-ASSEMBLY
  1. Engage the 12 claws.

  1. Install the meter hood sub-assembly with the screw.



9. INSTALL INSTRUMENT PANEL ORNAMENT (w/ Large Ornament Panel)
  1. Engage the 8 clips and 2 claws to install the instrument panel ornament.



10. INSTALL CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY (w/o Large Ornament Panel)
  1. Engage the 3 clips and 3 claws to install the center instrument cluster finish panel sub-assembly.



11. INSTALL INSTRUMENT SIDE PANEL LH

HINT:
Use the same procedure as for the RH side.