Home › Vehicle Exterior › WIPER / WASHER › WIPER SWITCH

WIPER SWITCH > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedure for the LHD and RHD vehicle.
  2. The procedure listed below is for the LHD vehicle.



1. REMOVE INSTRUMENT SIDE PANEL LH

HINT:
Use the same procedure as for the RH side.



2. REMOVE CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY


    B315188E01
  1. Using a moulding remover, disengage the 2 claws and 4 clips to remove the center instrument cluster finish panel sub-assembly.
    Text in Illustration 
    *1
    Moulding Remover



3. REMOVE METER HOOD SUB-ASSEMBLY


    B315191
  1. Remove the screw.

  1. Disengage the 12 claws, and then pull out the meter hood sub-assembly diagonally upwards to remove it.



4. REMOVE UPPER INSTRUMENT PANEL METER ORNAMENT


    B316758
  1. Remove the screw.

  1. Disengage the 6 claws and 2 clips.



    B316759
  1. Disengage the 2 claws that are holding the upper instrument panel meter ornament and steering column cover together.

  1. Disconnect the connector and remove the upper instrument panel meter ornament.



5. REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (w/o Knee Airbag)


    B312955
  1. Remove the 2 screws.



    B312956
  1. Disengage the 4 clips.

  1. Disengage the 4 claws and separate the No. 1 instrument panel under cover sub-assembly.



    B313000E01
  1. w/ Automatic Air Conditioning System for RHD:

    1. Disengage the guide and disconnect the aspirator hose.

    2. Disconnect the connector.

  1. Disconnect each connector and remove the No. 1 instrument panel under cover sub-assembly.
    Text in Illustration 
    *1
    Aspirator Hose



6. REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (w/ Knee Airbag)


    E252480
  1. Remove the screw.



    E252481
  1. Disengage the 6 clips.

  1. Disengage the 2 claws and separate the No. 1 instrument panel under cover sub-assembly.

  1. Disconnect each connector and remove the No. 1 instrument panel under cover sub-assembly.



7. REMOVE STEERING COLUMN COVER SUPPORT (w/ Entry and Start System)


B314879
  1. Disengage the 4 claws and remove the steering column cover support.



8. REMOVE LOWER STEERING COLUMN COVER


    B314880
  1. While turning the steering wheel assembly to the right and left, remove the 2 screws.



    B314881
  1. w/ Knee Airbag

    1. Disengage the 4 claws and remove the lower steering column cover.



    B310884
  1. w/o Knee Airbag

    1. Disengage the 6 claws and remove the lower steering column cover.



9. REMOVE UPPER STEERING COLUMN COVER


    B322438
  1. Disengage the 2 claws and remove the upper steering column cover.



10. REMOVE WINDSHIELD WIPER SWITCH ASSEMBLY


B314882E01
  1. Disconnect the 2 connectors.

  1. Using a screwdriver, disengage the claw and remove the windshield wiper switch assembly as shown in the illustration.
    Text in Illustration 
    *1
    Protective Tape

    NOTICE:
    Do not press the claw too hard, as it mat get damaged.

    HINT:
    Tape the screwdriver tip before use.