CLUTCH PEDAL (for LHD) > REMOVAL |
| 1. REMOVE POWER STEERING ECU ASSEMBLY |
| 2. SEPARATE STEERING INTERMEDIATE SHAFT ASSEMBLY |
![]() |
Put matchmarks on the steering intermediate shaft assembly and the steering column assembly.
| *a | Matchmark |
Remove the bolt and separate the steering intermediate shaft assembly from the steering column assembly.
| 3. REMOVE CLUTCH PEDAL SUPPORT SUB-ASSEMBLY |
![]() |
Disconnect the 3 connectors.
![]() |
Disconnect the connector and wire harness clamp.
![]() |
Remove the clip and the clevis pin, and separate the clutch master cylinder push rod clevis from the clutch pedal lever sub-assembly.
![]() |
Remove the clip and push rod pin, and separate the brake master cylinder push rod clevis from the brake pedal.
![]() |
Remove the 2 nuts and separate the clutch master cylinder assembly.
![]() |
Remove the 3 bolts, 4 nuts and the clutch pedal support sub-assembly.
![]() | Bolt |
![]() | Nut |
| 4. REMOVE CLUTCH START SWITCH ASSEMBLY |
Disconnect the clutch start switch connector.
![]() |
Remove the nut and the clutch start switch assembly from the clutch pedal support sub-assembly.
| 5. REMOVE CLUTCH SWITCH ASSEMBLY |
![]() |
Remove the nut and the clutch switch assembly from the clutch pedal support sub-assembly.
| 6. REMOVE CLUTCH PEDAL SPRING |
![]() |
Remove the 2 E-rings and the 2 clevis pins.
Remove the assist rod A, assist rod B, clutch pedal spring and assist bush.
Remove the 2 bushes from the clutch pedal sub-assembly and clutch pedal support sub-assembly.
| 7. REMOVE CLUTCH PEDAL SUB-ASSEMBLY |
![]() |
Using a pin punch (3 mm (0.118 in.)) and a hammer, tap out the straight pin and remove the clutch pedal lever sub-assembly.
![]() |
Remove the clutch pedal sub-assembly and 2 clutch pedal bushes from the clutch pedal support sub-assembly.
| 8. REMOVE CLUTCH PEDAL STOPPER |
![]() |
Remove the clutch pedal stopper from the clutch pedal support sub-assembly.
| 9. REMOVE NO. 1 CLUTCH PEDAL CUSHION |
Remove the No. 1 clutch pedal cushion from the clutch pedal sub-assembly.
| 10. REMOVE CLUTCH PEDAL PAD |
Remove the clutch pedal pad from the clutch pedal sub-assembly.