CLUTCH PEDAL (for RHD) > REMOVAL |
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 2. REMOVE LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY (w/ Knee Airbag) |
| 3. DISCONNECT CLUTCH MASTER CYLINDER ASSEMBLY |
![]() |
Disconnect the 2 connectors.
![]() |
Remove the clip and the clevis pin, and separate the clutch master cylinder push rod clevis from the clutch pedal sub-assembly.
![]() |
Remove the 2 nuts and separate the clutch master cylinder assembly from the clutch pedal support sub-assembly.
| 4. REMOVE CLUTCH PEDAL SUPPORT SUB-ASSEMBLY |
![]() |
Remove the bolt and the clutch pedal support sub-assembly.
| 5. REMOVE CLUTCH START SWITCH ASSEMBLY |
![]() |
Disconnect the clamp.
Remove the nut and the clutch start switch assembly from the clutch pedal support sub-assembly.
| 6. REMOVE CLUTCH SWITCH ASSEMBLY |
![]() |
Remove the nut and the clutch switch assembly from the clutch pedal support sub-assembly.
| 7. REMOVE CLUTCH PEDAL SPRING |
![]() |
Remove the 2 E-rings and the 2 clevis pins.
Remove the assist rod A, assist rod B, clutch pedal spring and assist bush.
| 8. REMOVE CLUTCH PEDAL SUB-ASSEMBLY |
![]() |
Remove the bolt, the nut and the clutch pedal sub-assembly from the clutch pedal support sub-assembly.
| 9. REMOVE CLUTCH PEDAL SHAFT COLLAR |
![]() |
Remove the 2 clutch pedal bushes and the clutch pedal shaft collar from the clutch pedal sub-assembly.
| 10. REMOVE BUSH |
![]() |
Remove the 3 bushes.
| 11. REMOVE NO. 1 CLUTCH PEDAL CUSHION |
![]() |
Remove the 2 No. 1 clutch pedal cushions.
| 12. REMOVE NO. 2 CLUTCH PEDAL CUSHION |
![]() |
Remove the No. 2 clutch pedal cushion from the clutch pedal sub-assembly.
| 13. REMOVE CLUTCH PEDAL PAD |
Remove the clutch pedal pad from the clutch pedal sub-assembly.