Home › Drivetrain ยท CLUTCH › CLUTCH MASTER CYLINDER (for RHD)

CLUTCH MASTER CYLINDER (for RHD) > REMOVAL

for Preparation Click here



1. DRAIN CLUTCH FLUID

NOTICE:
Immediately wash off any clutch fluid that comes into contact with any painted surfaces.

HINT:
If any work is done on the clutch system or if air in the clutch lines is suspected, bleed the air from the system.



2. REMOVE LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY
(Click here)


3. REMOVE CLUTCH MASTER CYLINDER PUSH ROD CLEVIS


    C258490
  1. Remove the clip and the clevis pin, and separate the clutch master cylinder push rod clevis from the clutch pedal sub-assembly.



4. REMOVE CLUTCH MASTER CYLINDER ASSEMBLY


    C258503
  1. Remove the union bolt, 2 gaskets and the master cylinder to the release cylinder hose from the clutch release cylinder assembly.

    HINT:
    Use a container to collect the fluid.



    C257594
  1. Remove the 2 nuts, the clutch master cylinder assembly, and the clutch flexible hose bracket.

  1. Remove the sheet from the clutch master cylinder assembly.



5. REMOVE CLUTCH MASTER CYLINDER TO FLEXIBLE HOSE TUBE


    C257595
  1. Using a union nut wrench (10 mm), disconnect the clutch master cylinder to flexible hose tube from the master cylinder to release cylinder hose.

    HINT:
    Use a container to collect the fluid.

  1. Remove the clip and the clutch flexible hose bracket.

  1. Using a union nut wrench (10 mm), remove the clutch master cylinder to flexible hose tube from the clutch master cylinder assembly.

    HINT:
    Use a container to collect the fluid.