CLUTCH RELEASE CYLINDER > INSTALLATION |
| 1. INSTALL CLUTCH RELEASE CYLINDER ASSEMBLY |
Install the clutch release cylinder assembly with the 2 bolts.
| 2. CONNECT MASTER CYLINDER TO RELEASE CYLINDER HOSE |
Install the master cylinder to release cylinder hose with a union bolt and 2 new gaskets.
| 3. FILL CLUTCH FLUID |
![]() |
Fill the clutch fluid.
| 4. BLEED CLUTCH LINE |
![]() |
Connect a vinyl tube to the clutch release cylinder bleeder plug.
Depress the clutch pedal 5 times, and then loosen the clutch release cylinder bleeder plug while the pedal is depressed (Step C).
When fluid no longer comes out, tighten the clutch release cylinder bleeder plug, and then release the clutch pedal (Step D).
Repeat Steps C and D until all the air in the fluid is completely bled out.
Tighten the clutch release cylinder bleeder plug.
Depress the clutch pedal 10 times or more and confirm its operation.
| 5. INSPECT FOR CLUTCH FLUID LEAK |
| 6. INSPECT CLUTCH FLUID LEVEL |
![]() |
Check the clutch fluid level.
If clutch fluid level is lower than the MIN line, check for leaks and inspect the clutch lines. If necessary, refill the master cylinder reservoir sub-assembly with clutch fluid to the MAX line after repair or replacement.