Home › Vehicle Interior › METER / GAUGE / DISPLAY › METER / GAUGE SYSTEM

METER / GAUGE SYSTEM > DATA LIST / ACTIVE TEST

for Preparation Click here



DATA LIST

HINT:
Using the GTS to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.

  1. Connect the GTS to the DLC3.

  2. Turn the ignition switch to ON.

  3. Turn the GTS on.

  4. Enter the following menus: Body Electrical / Combination Meter / Data List.

  5. According to the display on the tester, read the Data List.

    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    ODO/TRIP Change SW
    ODO/TRIP change switch
    ON or OFF
    ON: ODO/TRIP switch pushed
    OFF: ODO/TRIP switch not pushed
    -
    Tail Cancel SW
    Light control rheostat switch (cancel switch)
    ON or OFF
    ON: Light control rheostat switch (cancel switch) → TAIL
    OFF: Light control rheostat switch (cancel switch) → OFF
    -
    P-Seatbelt Buckle SW
    Buckle switch (Front passenger side)
    ON or OFF
    ON: Front passenger side seat belt is fastened
    OFF: Front passenger side seat belt is unfastened
    -
    Multi Display Select Switch
    Multi Display Select Switch
    ON or OFF
    ON: DISP switch pushed
    OFF: DISP switch not pushed
    -
    +B Voltage Value
    +B voltage
    Min.: 0
    Max.: 25.5
    Below 1 to 14
    Unit: V
    Vehicle Speed Meter
    Vehicle speed
    Min.: 0 (0)
    Max.: 255 (158)
    Approximately same as actual vehicle speed (When vehicle is being driven)
    Unit: km/h (mph)
    Engine Rpm
    Engine speed
    Min.: 0
    Max.: 12750
    Approximately same as actual engine speed (when engine is running)
    Unit: rpm
    Coolant Temperature
    Engine coolant temperature
    Min.: 0
    Max.: 127.5
    After warming up:
    80 to 108 (176 to 226)
    Unit: °C (°F)
    Fuel Input
    Fuel sender gauge input
    Min.: 0
    Max.: 127.5
    Fuel sender input value
    Unit: Liter
    Ambient Temperature
    Ambient temperature
    Min.: -40 (-40)
    Max.: 87.5 (189.5)
    Same as outside temperature
    Unit: °C (°F)
    Rheostat value
    Light control rheostat switch input
    Min.: 0
    Max.: 100
    Displays rheostat volume figure
    0 to 100
    Unit: %
    Quantity of Outside Light
    Light control rheostat switch output
    Min.: 0
    Max.: 100
    Displays rheostat volume figure
    0 to 100
    Unit: %
    Key Remind Sound
    Key remind sound
    FAST, NORMAL or SLOW
    Display key reminder buzzer speed setting
    -
    Tail Remind Buzzer
    Tail remind buzzer
    ON or OFF
    ON: Tail remind buzzer ON
    OFF: Tail remind buzzer OFF
    -
    Speed Alarm Buzzer
    Speed alarm buzzer
    ON or OFF
    ON: Speed alarm buzzer ON
    OFF: Speed alarm buzzer OFF
    -
    Driver Side Seatbelt Warning Buzzer
    Driver seat belt warning buzzer
    ON or OFF
    ON: Driver side seat belt warning buzzer ON
    OFF: Driver side seat belt warning buzzer OFF
    -
    P-Seatbelt Warning Buzzer
    Front passenger seat belt warning buzzer
    ON or OFF
    ON: Front passenger side seat belt warning buzzer ON
    OFF: Front passenger side seat belt warning buzzer OFF
    -
    Number of Trouble Code
    The DTC number which is currently output
    -
    -

    HINT:
    Items for which there are no settings do not appear on the GTS, or do not operate.


PERFORM ACTIVE TEST

HINT:
Using the GTS to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.

  1. Connect the GTS to the DLC3.

  2. Turn the ignition switch to ON.

  3. Turn the GTS on.

  4. Enter the following menus: Body Electrical / Combination Meter / Active Test.

  5. According to the display on the tester, perform the Active Test.

    Combination Meter 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    Speed Meter Operation
    Speedometer
    0, 40, 80, 120, 160, 200, 240 km/h
    -
    Tachometer Operation
    Tachometer
    0, 1000, 2000, 3000, 4000, 5000, 6000, 7000 rpm
    -
    Fuel Meter Operation
    Fuel gauge
    EMPTY, 1/2, FULL
    -
    A/T Indicator Operation 1
    A/T shift indicator light
    P, R, N, D, 4, 3, 2, L
    -
    A/T Indicator Operation 2
    A/T shift indicator light
    5, 6, M
    -
    A/T Indicator Operation 3
    A/T shift indicator light
    D
    -
    Meter Display 1
    Drive monitor display
    6, 5, 4, 3, 2, 1, 0, All
    Vehicle is stopped and engine is idling
    Meter Display 2
    Drive monitor display
    9, 8, 7
    Vehicle is stopped and engine is idling
    Indicat. Lamp Beam
    Hi-beam indicator light
    OFF/ON
    Vehicle is stopped and engine is idling
    Indicat. Lamp Fr FOG
    Front fog indicator light
    OFF/ON
    Vehicle is stopped and engine is idling
    Indicat. Lamp Rr FOG
    Rear fog indicator light
    OFF/ON
    Vehicle is stopped and engine is idling
    Indicat. Lamp Airbag
    Airbag warning light
    OFF/ON
    Vehicle is stopped and engine is idling
    Driver Side Seat Belt
    Driver side seat belt warning light
    OFF/ON
    Vehicle is stopped and engine is idling
    Front Passenger Side Seat Belt
    Front passenger seat belt warning light
    OFF/ON
    Vehicle is stopped and engine is idling
    Indicat. Lamp Doors All Open
    Door warning light
    OFF/ON
    Vehicle is stopped and engine is idling
    Indicat.Lamp Fuel
    Low fuel warning light
    OFF/ON
    Vehicle is stopped and engine is idling
    Indicat. Lamp ABS
    ABS warning light
    OFF/ON
    Vehicle is stopped and engine is idling
    Indicat. Lamp Slip
    SLIP indicator light
    OFF/ON
    Vehicle is stopped and engine is idling
    VSC TRC Indicator
    TRC OFF/TRC OFF indicator light
    OFF/ON
    Vehicle is stopped and engine is idling
    Indicat. Tire Pressure Warning System
    TIRE PRESSURE warning light
    OFF/ON
    Vehicle is stopped and engine is idling
    Indicat. Lamp Brake
    Brake warning light
    OFF/ON
    Vehicle is stopped and engine is idling
    SPORT Indicator
    Sport indicator light
    OFF/ON
    Vehicle is stopped and engine is idling
    Indicat. Lamp ECT SNOW
    Snow indicator light
    OFF/ON
    Vehicle is stopped and engine is idling
    A/T Oil Temperature Operation
    A/T oil temperature warning light
    OFF/ON
    Vehicle is stopped and engine is idling
    Indicat. EPS
    EPS warning light
    OFF/ON
    Vehicle is stopped and engine is idling
    Indicat. Lamp Cruise
    Cruise indicator light (green)
    OFF/ON
    Vehicle is stopped and engine is idling
    Indicat. SIL (Up)
    Shift up indicator light
    OFF/ON
    Vehicle is stopped and engine is idling
    Indicat. SIL (Down)
    Shift down indicator light
    OFF/ON
    Vehicle is stopped and engine is idling
    Indicat. SET
    SET indicator light
    OFF/ON
    Vehicle is stopped and engine is idling
    Indicat. VSC OFF
    VSC OFF indicator light
    OFF/ON
    Vehicle is stopped and engine is idling
    Cruise Warning
    Cruise warning light (yellow)
    OFF/ON
    Vehicle is stopped and engine is idling
    Smart System Indicator
    Smart system indicator light (green)
    OFF/ON
    Vehicle is stopped and engine is idling
    Smart System Warning
    Smart system warning light (yellow)
    OFF/ON
    Vehicle is stopped and engine is idling
    Check Engine Warning
    Check engine warning light
    OFF/ON
    Vehicle is stopped and engine is idling
    Water Temperature Meter Operation
    Water temperature gauge
    LOW, NORMAL, HIGH
    Vehicle is stopped and engine is idling

    HINT:
    1. Items for which there are no settings do not appear on the GTS, or do not operate.
    2. Telltales for which there are no settings do not operate.
    3. When not functioning normally, there may be a combination meter assembly malfunction.