Home › Engine / Hybrid System › FA20 STARTING › RELAY

RELAY > ON-VEHICLE INSPECTION

for Preparation Click here



1. INSPECT ST RELAY


    B060778E48
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    1 - 2
    Battery voltage not applied to terminals 1 and 2
    Measurement temperature : 20 °C
    93.8 to 136.4 kΩ
    3 - 5
    Battery voltage not applied to terminals 1 and 2
    10 kΩ or higher
    Battery voltage applied to terminals 1 and 2
    Below 1 Ω

    If the result is not as specified, replace the starter relay.



2. REMOVE INHIBITOR RELAY


    B060778E48
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    1 - 2
    Battery voltage not applied to terminals 1 and 2
    Measurement temperature : 20 °C
    93.8 to 136.4 kΩ
    3 - 5
    Battery voltage not applied to terminals 1 and 2
    10 kΩ or higher
    Battery voltage applied to terminals 1 and 2
    Below 1 Ω

    If the result is not as specified, replace the starter relay.



3. INSPECT ST CUT RELAY


    A280268E01
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    1 - 2
    Battery voltage not applied to terminals 1 and 2
    Measurement temperature : 20 °C
    93.8 to 136.4 kΩ
    3 - 4
    Battery voltage not applied to terminals 1 and 2
    Below 1 Ω
    Battery voltage applied to terminals 1 and 2
    10 kΩ or higher
    3 - 5
    Battery voltage not applied to terminals 1 and 2
    10 kΩ or higher
    Battery voltage applied to terminals 1 and 2
    Below 1 Ω

    If the result is not as specified, replace the starter relay.



4. INSPECT IGS RELAY


    B060778E48
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    1 - 2
    Battery voltage not applied to terminals 1 and 2
    Measurement temperature : 20 °C
    93.8 to 136.4 kΩ
    3 - 5
    Battery voltage not applied to terminals 1 and 2
    10 kΩ or higher
    Battery voltage applied to terminals 1 and 2
    Below 1 Ω

    If the result is not as specified, replace the starter relay.