Home › Vehicle Interior › HEATING / AIR CONDITIONING › AIR CONDITIONING SYSTEM (for Manual Air Conditioning System)

AIR CONDITIONING SYSTEM (for Manual Air Conditioning System) > DATA LIST / ACTIVE TEST

for Preparation Click here



DATA LIST
Using the GTS to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.

NOTICE:
In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.

  1. Connect the GTS to the DLC3.

  2. Turn the ignition switch to ON.

  3. Turn the GTS on.

  4. Enter the following menus: Body Electrical / Main Body ECU / Data List.

  5. Check the value(s) by referring to the table below.

    Main Body ECU 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Evaporator Fin Sensor Voltage
    Evaporator temperature sensor /
    Min.: 0V
    Max.: 21.4V
    Actual evaporator temperature displayed Sensor Voltage
    -
    A/C SW Input
    A/C Switch Input
    OFF or ON
    -
    -
    A/C SW Output
    A/C Switch Output
    OFF or ON
    -
    -

    Engine 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    A/C Pressure Normal SW
    A/C Pressure Normal Switch
    OFF or ON
    -
    -
    A/C Signal
    A/C Signal /
    OFF or ON
    A/C switch operated: ON (when switch is pressed)
    -
    A/C switch not operated: OFF (when switch is not pressed)
    -
    A/C Magnetic Clutch Relay
    A/C Magnetic Clutch Relay /
    OFF or ON
    -
    -
    Air Conditioner FB Val
    Compensation flow rate according to air conditioner load /
    Min.: -150
    Max.: 149.99
    -
    For use when engine stall, starting problems or rough idle is present.


ACTIVE TEST
Using the GTS to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.
  1. Connect the GTS to the DLC3.

  2. Turn the ignition switch to ON.

  3. Turn the GTS on.

  4. Enter the following menus: Powertrain / Engine / Active Test.

  5. Check the operation by referring to the table below.

    Engine 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    A/C Magnetic Clutch Relay
    A/C system operation
    OFF, ON
    -