Home › Vehicle Interior › HEATING / AIR CONDITIONING › AIR CONDITIONING SYSTEM (for Automatic Air Conditioning System)

AIR CONDITIONING SYSTEM (for Automatic Air Conditioning System) > ACTUATOR CHECK

for Preparation Click here



ACTUATOR CHECK
  1. Start the engine and warm it up.

  2. Perform the indicator check (Click here).

    HINT:
    1. After the indicator check is completed the system enter the DTC check mode automatically.
    1. Press the "A/C" switch to cancel the check mode.



  3. E234476E01
  4. Push the "DEF" switch to perform the actuator check.

    HINT:
    Be sure to perform the actuator check after starting the engine.



  5. E234498E01
  6. As the actuator check is repeated from steps 1 to 8 at 1 second intervals, check the temperature and air flow visually and by hand.

    HINT:
    1. The display blinks at 1 second intervals in the step operation.
    2. Push the "OFF" switch to finish panel diagnosis.
    3. Push the "AUTO" switch to enter the sensor check mode.


    Step No.
    Display Code
    Conditions
    Blower Level
    Air Mix Damper
    Airflow Vent
    Air Inlet Damper
    Compressor
    1
    81
    L0
    0% open
    FACE
    FRESH
    OFF
    2
    82
    L0
    0% open
    FACE
    RECIRCULATION / FRESH
    ON
    3
    83
    M1
    0% open
    FACE
    RECIRCULATION / FRESH
    ON
    4
    84
    M1
    50% open
    B/L
    FRESH
    ON
    5
    85
    M1
    50% open
    FOOT
    FRESH
    ON
    6
    86
    M3
    100% open
    FOOT
    FRESH
    ON
    7
    87
    M3
    100% open
    F/D
    FRESH
    ON
    8
    88
    Hi
    100% open
    DEF
    FRESH
    ON



  7. E236601E01
  8. If the steps are difficult to read because they change automatically, push the "A/C" switch to display the steps one at a time so that they can be read easily. The items are displayed step by step each time the "A/C" switch is pushed.

    HINT:
    1. Push the "OFF" switch to finish panel diagnosis.
    2. Push the "AUTO" switch to enter the sensor check mode.