Home › Brake › BRAKE SYSTEM (OTHER) › BRAKE PEDAL (for LHD M/T)

BRAKE PEDAL (for LHD M/T) > ADJUSTMENT

for Preparation Click here



1. CHECK AND ADJUST BRAKE PEDAL HEIGHT


    C260020E02
  1. Check the pedal height.
    Text in Illustration 
    *1
    Clevis Lock Nut
    *2
    Floor mat
    *a
    Pedal Height
    Standard Pedal Height from floor mat 
    for M/T
    145mm
    (5.709in.)
    for A/T
    150mm
    (5.906 in.)

  1. Adjust the pedal height.

    1. Remove the No. 1 instrument panel under cover sub-assembly.

    2. Disconnect the connector from the stop light switch.

    3. Remove the stop light switch.

    4. Loosen the push rod clevis lock nut.

    5. Adjust the pedal height by turning the push rod.
      Standard Pedal Height from floor mat 
      for M/T
      145mm
      (5.709in.)
      for A/T
      150mm
      (5.906 in.)

    6. Tighten the brake master cylinder push rod clevis lock nut.

      Torque:
      19 N*m{ 194 kgf*cm , 14 ft.*lbf }

    7. Install the stop light switch (Click here).

    8. Connect the connector to the switch.

    9. Check that the stop light does not illuminate when the brake pedal is not stepped.



2. CHECK BRAKE PEDAL FREE PLAY


    C111306E03
  1. Stop the engine. Depress the pedal several times until there is no vacuum in the booster. Then release the pedal.

  1. Depress the pedal until resistance is felt.

  1. Check the pedal free play by measuring the distance between the position in the previous step and the pedal released position.

    Standard pedal free play:
    0.5 to 2.0mm
    (0.020 to 0.079in.)

    Text in Illustration 
    *a
    Pedal Free Play

    HINT:
    Check the brake pedal free play at the same location as that used when checking the brake pedal height.



3. CHECK BRAKE PEDAL RESERVE DISTANCE
  1. Release the parking brake pedal. Start the engine, and when the pressure in the brake booster reaches 66.7 kPa (500 mmHg, 19.6 in.Hg), proceed with the next step.



    C219250E01
  1. Depress the pedal and check the pedal reserve distance.
    Text in Illustration 
    *1
    Floor mat
    *a
    Pedal Reserve Distance

    Standard Pedal Reserve Distance from the floor mat at 490 N (50 kgf, 110.2 lbf):
    More than 55 mm (2.165 in.)

    If the distance is not as specified, troubleshoot the brake system.

    HINT:
    Check the brake pedal reserve distance at the same location as that used when checking the brake pedal height.