BRAKE MASTER CYLINDER (for LHD) > REMOVAL |
| 1. REMOVE FRONT WHEEL LH |
| 2. DRAIN BRAKE FLUID |
| 3. REMOVE FRONT SUSPENSION UPPER TO COWL BRACE SUB-ASSEMBLY LH |
| 4. REMOVE BRAKE MASTER CYLINDER SUB-ASSEMBLY |
Release the vacuum from the booster by depressing the brake pedal several times.
Disconnect the brake fluid level switch connector.
![]() |
Using a union nut wrench 12 mm, disconnect the 2 brake tubes from the brake master cylinder sub-assembly.
![]() |
Remove the 2 nuts and the brake master cylinder sub-assembly from the brake booster assembly.
| 5. REMOVE SEAL |
Remove the seal.