ROOF HEADLINING > REMOVAL |
| 1. PRECAUTION |
| 2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 3. REMOVE NO. 2 INSTRUMENT PANEL SPEAKER PANEL SUB-ASSEMBLY |
![]() |
Apply protective tape to the area shown in the illustration.
| *1 | Protective Tape |
![]() |
Using a moulding remover, disengage the 6 claws and remove the No. 2 instrument panel speaker panel sub-assembly.
| *1 | Moulding Remover |
Disconnect the connector.
| 4. REMOVE NO. 1 INSTRUMENT PANEL SPEAKER PANEL SUB-ASSEMBLY |
| 5. REMOVE FRONT PILLAR GARNISH LH |
![]() |
Pull the upper part of the front pillar garnish LH in the direction of the arrow (1), and disengage the 2 clips and the front pillar garnish clip.
| *1 | Front Pillar Garnish Clip |
Pull the front pillar garnish LH in the direction of the arrow (2) and disengage the 2 guides.
![]() |
Turn the front pillar garnish LH in the direction of the arrow.
Disengage the tip of the front pillar garnish clip and remove the front pillar garnish LH.
| *1 | Front Pillar Garnish Clip |
![]() |
Protect the curtain shield airbag assembly (w/curtain shield airbag).
| *1 | Curtain Shield Airbag Assembly |
| *2 | Adhesive Tape |
| *3 | Protective Cover |
Cover the airbag with a piece of cloth or nylon and secure the edges of the cover with tape as shown in the illustration.
| 6. REMOVE FRONT PILLAR GARNISH RH |
| 7. REMOVE FRONT DOOR SCUFF PLATE LH |
![]() |
Disengage the 6 claws and remove the front door scuff plate LH.
| 8. REMOVE FRONT DOOR SCUFF PLATE RH |
| 9. REMOVE FRONT DOOR OPENING TRIM WEATHERSTRIP LH |
![]() |
Remove the front door opening trim weatherstrip LH.
| 10. REMOVE FRONT DOOR OPENING TRIM WEATHERSTRIP RH |
| 11. REMOVE COWL SIDE TRIM BOARD LH |
![]() |
Remove the clip.
Disengage the 2 clips and remove the cowl side trim board LH.
| 12. REMOVE COWL SIDE TRIM BOARD RH |
| 13. SEPARATE FRONT SEAT OUTER BELT ASSEMBLY LH |
![]() |
Turn back the floor anchor cover.
| *1 | Floor Anchor Cover |
Loosen the bolt and disconnect the floor anchor of the front seat outer belt assembly.
| 14. SEPARATE FRONT SEAT OUTER BELT ASSEMBLY RH |
| 15. REMOVE SEPARATE TYPE REAR SEAT CUSHION ASSEMBLY LH |
![]() |
Remove the bolt.
Disengage the hook and remove the separate type rear seat cushion assembly LH.
| 16. REMOVE SEPARATE TYPE REAR SEAT CUSHION ASSEMBLY RH |
| 17. REMOVE LUGGAGE COMPARTMENT INNER TRIM COVER LH |
![]() |
Fold down the bench type rear seatback assembly.
Disengage the 2 clips and disconnect the luggage compartment inner trim cover LH.
| 18. REMOVE LUGGAGE COMPARTMENT INNER TRIM COVER RH |
| 19. REMOVE LUGGAGE COMPARTMENT TRIM COVER LH |
![]() |
Pull up the rear seatback assembly.
Remove the clip.
Disengage the 8 clips and remove the luggage compartment trim cover LH.
| 20. REMOVE LUGGAGE COMPARTMENT TRIM COVER RH |
| 21. REMOVE QUARTER TRIM LID SUB-ASSEMBLY LH |
![]() |
Along the arrow in the illustration, disengage the 6 claws.
![]() |
Disengage the 3 clips and 2 guides.
![]() |
Push the lid cover clip knobs in the direction of the arrow to remove the 3 lid cover clips along with the quarter trim lid sub-assembly LH.
| *1 | Lid Cover Clip |
Remove the 3 lid cover clips from the lid cover LH.
| 22. REMOVE QUARTER TRIM LID SUB-ASSEMBLY RH |
| 23. REMOVE REAR WINDOW SIDE GARNISH LH |
![]() |
Remove the bolt.
Disengage the 2 clips and guide remove the rear window side garnish LH.
| 24. REMOVE REAR WINDOW SIDE GARNISH RH |
| 25. REMOVE REAR QUARTER TRIM FRONT GARNISH LH |
![]() |
Remove the 2 bolts.
Disengage the clip and claw remove the rear quarter trim front garnish LH.
| 26. REMOVE REAR QUARTER TRIM FRONT GARNISH RH |
| 27. REMOVE CENTER PILLAR GARNISH LH |
![]() |
Remove the 2 bolts and clip.
Disengage the clips and 2 guides to remove the center pillar garnish LH.
| 28. REMOVE CENTER PILLAR GARNISH RH |
| 29. REMOVE MAP LIGHT ASSEMBLY |
![]() |
Disengage the 2 claws.
![]() |
Disengage the 2 guides and disconnect the map light assembly.
![]() |
Disconnect the connector and remove the map light assembly.
| 30. REMOVE VISOR ASSEMBLY LH |
![]() |
Remove the 2 screws.
![]() |
Disconnect the connector and remove the visor assembly LH (w/ Illumination).
| 31. REMOVE VISOR ASSEMBLY RH |
| 32. REMOVE VISOR HOLDER |
![]() |
Disengage the 2 claws remove the 2 visor holders.
| 33. REMOVE ROOF HEADLINING ASSEMBLY |
![]() |
Disengage the 3 clamps and disconnect the connector from the front pillar RH.
![]() |
Disengage the 2 clamps and disconnect the connector from the front pillar LH.
![]() |
Remove the 3 clips at the rear of the roof headlining.
![]() |
Disconnect the antenna cord sub-assembly connector.
![]() |
Disengage the clip at the front of the roof headlining, and remove the roof headlining assembly.
![]() |
Remove the roof headlining assembly from the vehicle through the front passenger side door.