Home › Drivetrain · TX6A AUTOMATIC TRANSMISSION / TRANSAXLE › SHIFT PADDLE SWITCH

SHIFT PADDLE SWITCH > INSPECTION

for Preparation Click here



1. INSPECT SHIFT PADDLE SWITCH (TRANSMISSION SHIFT SWITCH ASSEMBLY)


    C261037E01
  1. Measure the resistance according to the value(s) in the table below.
    Text in Illustration 
    *a
    Component without harness connected
    (Shift Paddle Switch (transmission shift switch assembly))

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    1 - 3
    Pull continuously "+"
    (Up shift)
    Below 1 Ω
    Release "+"
    10 Ω or higher
    1 - 4
    Pull continuously "-"
    (Down shift)
    Below 1 Ω
    Release "-"
    10 Ω or higher

    If the resistance value are not as specified, replace the shift paddle switch (transmission shift switch assembly).