Use the same procedure for both the RH and LH sides.
1. ADJUST WASHER NOZZLE SUB-ASSEMBLY
Using a 2 thin-bladed screwdrivers with its tip wrapped in protective tape, adjust the direction of the washer nozzle sub-assembly.
Text in Illustration
*1
Protective Tape
-
-
HINT:
Use the upper and lower adjustment grooves of the nozzle to adjust the washer nozzle.
NOTICE:
Do not insert the screwdriver into the washer fluid spraying nozzle. Doing so may damage the washer fluid spraying nozzle, resulting in spraying problems.