Home › Vehicle Exterior › WIPER / WASHER › HEADLIGHT CLEANER ACTUATOR

HEADLIGHT CLEANER ACTUATOR > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedure for the RH and LH sides.
  2. The procedure listed below is for the LH side.



1. REMOVE FRONT BUMPER COVER
(Click here)


2. REMOVE HEADLIGHT WASHER ACTUATOR SUB-ASSEMBLY


    B405802E01
  1. Disconnect the joint clamp and headlight washer hose as indicated by the arrows in the order shown in the illustration.
    Text in Illustration 
    *1
    Joint clamp
    *a
    Push



    E250581
  1. Remove the clip.

  1. Remove the bolt and the headlight washer actuator sub-assembly.