Home › Vehicle Exterior › WIPER / WASHER › FRONT WIPER MOTOR

FRONT WIPER MOTOR > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedure for the LHD and RHD vehicles.
  2. The procedure listed below is for the LHD vehicles.



1. REMOVE WINDSHIELD WIPER ARM COVER


    B314860E01
  1. Using a screwdriver, disengage the claw and remove the windshield wiper arm cover, as shown in the illustration.
    Text in Illustration 
    *1
    Protective Tape

    HINT:
    1. Tape the screwdriver tip before use.
    2. Use the same procedure for both the RH and LH sides.



2. REMOVE WINDSHIELD WIPER ARM AND BLADE ASSEMBLY LH


    B314861
  1. Remove the nut and the windshield wiper arm and blade assembly LH.



3. REMOVE WINDSHIELD WIPER ARM AND BLADE ASSEMBLY RH


    B314862
  1. Remove the nut and the windshield wiper arm and blade assembly RH.



4. REMOVE FRONT FENDER TO COWL SIDE SEAL RH


    B309212
  1. Disengage the 4 claws.

  1. Remove the clip and the front fender to cowl side seal RH.



5. REMOVE FRONT FENDER TO COWL SIDE SEAL LH

HINT:
Use the same procedure as for the RH side.



6. REMOVE COWL VENTILATOR LOUVER
  1. Using a clip remover, remove the 3 clips.



  1. While pressing the claws, as shown in the illustration, remove the 4 cowl top ventilator louver clips.


    B314863E01


    Text in Illustration 
    *1
    Cowl Top Ventilator Louver Clip
    -
    -

    NOTICE:
    Do not pull forcibly the cowl top ventilator louver clips because they may get damaged.

  1. Disengage the 15 guides and pull out the cowl ventilator louver, as shown in the illustration.



7. REMOVE FRONT WIPER MOTOR AND LINK ASSEMBLY
  1. Operate the wiper and stop the windshield wiper motor at the automatic stop position.



    B314871E01
  1. Disconnect the connector.

  1. Remove the 2 bolts.

  1. Disengage the grommet and remove the front wiper motor and link assembly, as shown in the illustration.
    Text in Illustration 
    *1
    Grommet

    NOTICE:
    Be careful not to damage the windshield when removing the front wiper motor and link assembly.



8. REMOVE CAP


    B309215
  1. Disengage the claw and remove the cap.

    HINT:
    Use the same procedure for both the RH and LH sides.



9. REMOVE FRONT WIPER CRANK SUB-ASSEMBLY


    B314865E01
  1. Using a screwdriver, separate the No. 1 rod from the crank arm pivot of the front wiper crank sub-assembly, as shown in the illustration.
    Text in Illustration 
    *1
    Protective Tape

    HINT:
    Tape the screwdriver tip before use.



    B314866
  1. Remove the nut and the front wiper crank sub-assembly.



10. REMOVE WINDSHIELD WIPER MOTOR ASSEMBLY


    B314867
  1. Using a T30 "TORX" socket wrench, remove the 2 bolts and the windshield wiper motor assembly from the windshield wiper link assembly.