Home › Vehicle Exterior › WIPER / WASHER › HEADLIGHT CLEANER MOTOR

HEADLIGHT CLEANER MOTOR > INSPECTION

for Preparation Click here



1. INSPECT HEADLIGHT CLEANER MOTOR AND PUMP ASSEMBLY

HINT:
The following check should be performed with the headlight cleaner motor and pump assembly installed to the washer jar.

  1. Fill the washer jar with washer fluid.



    E256419E01
  1. Connect a battery positive (+) lead to terminal 1 of the headlight cleaner motor and pump, and a battery negative (-) lead to terminal 2.

  1. Check that the washer fluid flows from the washer jar.

    OK:
    The washer fluid is pumped from the washer jar.

    Text in Illustration 
    *a
    Component without harness connected
    (Headlight Cleaner Motor and Pump Assembly)
    If the result is not as specified, replace the headlight cleaner motor and pump assembly.