WIRELESS DOOR LOCK CONTROL SYSTEM (w/o Entry and Start System) > DIAGNOSIS SYSTEM |
| CHECK DLC3 |
Check the DLC3 (Click here).
| INSPECT BATTERY VOLTAGE |
Measure the battery voltage.
| SELF-DIAGNOSTIC MODE (OPERATING IGNITION KEY CYLINDER) |
Switch to self-diagnostic mode.
Insert the key into the ignition key cylinder and remove it.
Within 5 seconds after the key is removed, insert it into the ignition key cylinder and then turn the ignition switch to ON then off once. (End in off)
Within 30 seconds after turning the ignition switch off, perform the following 9 times: Turn the ignition switch to ON then off. (End in off)
![]() |
Check that the system has switched to self-diagnostic mode by checking the interior light output pattern.
![]() |
Check that the system has switched to self-diagnostic mode by checking the wireless door lock buzzer output pattern (w/ Wireless Door Lock Buzzer Answer-back Function).
Check the diagnostic outputs when the door control transmitter module set sub-assembly switch is held down. The diagnostic outputs can be checked by the interior light and wireless door lock buzzer* patterns.
