Home › Vehicle Interior › THEFT DETERRENT / KEYLESS ENTRY › THEFT DETERRENT SYSTEM

THEFT DETERRENT SYSTEM > DATA LIST / ACTIVE TEST

for Preparation Click here



DATA LIST

HINT:
Using the GTS to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.

  1. Connect the GTS to the DLC3.

  2. Turn the engine switch on (IG).

  3. Turn the GTS on.

  4. Enter the following menus: Body Electrical / Main Body / Data List.

  5. According to the display on the GTS, read the Data List.

    Main Body 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Security System
    Theft deterrent system / OFF or ON
    Customization status displayed
    -
    D Door Courtesy SW
    Front RH door courtesy light switch signal / OFF or ON
    OFF: Driver side door closed
    ON: Driver side door open
    -
    D-Door Lock Pos SW
    Front RH door lock position switch signal / OFF or ON
    OFF: Driver side door locked
    ON: Driver side door unlocked
    -
    P Door Courtesy SW
    Front LH door courtesy light switch signal / OFF or ON
    OFF: Passenger side door closed
    ON: Passenger side door open
    -
    P-Door Lock Pos SW
    Front LH door lock position switch signal / OFF or ON
    OFF: Passenger side door locked
    ON: Passenger side door unlocked
    -
    Luggage Courtesy SW
    Luggage compartment door courtesy switch / OFF or ON
    OFF: Luggage compartment door closed
    ON: Luggage compartment door open
    -
    IG SW
    Engine switch status / OFF or ON
    OFF: Engine switch off
    ON: Engine switch on (IG)
    -
    ACC SW
    Engine switch status / OFF or ON
    OFF: Engine switch off
    ON: Engine switch on (ACC)
    -
    Hazard Output
    Hazard warning light signal output OFF or ON
    OFF: Hazard warning light not blinks
    ON: Hazard warning light blinks (Theft deterrent system is in alarm sounding state)
    -
    Horn Output
    Vehicle horn sounding signal output OFF or ON
    OFF: Vehicle horns not sounding
    ON: Vehicle horns sounding (Theft deterrent system is in alarm sounding state)
    -
    Immobiliser Light
    Security indicator light status / OFF or ON
    OFF: Security indicator light OFF
    ON: Security indicator light ON
    -


ACTIVE TEST

HINT:
Using the GTS to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. The Data List can be displayed while performing Active Tests.

  1. Connect the GTS to the DLC3.

  2. Turn the engine switch on (IG).

  3. Turn the GTS on.

  4. Enter the following menus: Body Electrical / Main Body / Active Test.

  5. According to the display on the GTS, perform the Active Test.

    Main Body 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    Security Indicator
    Security indicator light
    ON/OFF
    -
    Vehicle Horn
    Vehicle horns
    ON/OFF
    -