Home › Vehicle Exterior › LIGHTING (EXT) › HEADLIGHT ASSEMBLY (for HID Headlight)

HEADLIGHT ASSEMBLY (for HID Headlight) > DISASSEMBLY

for Preparation Click here


HINT:
  1. Use the same procedure for RH and LH sides.
  2. The procedure listed below is for LH side.



1. REMOVE HEADLIGHT COVER


    B312195
  1. Turn the headlight cover in the direction indicated by the arrow shown in the illustration, and remove it.



2. REMOVE DISCHARGE HEADLIGHT BULB


    B312196
  1. Turn the headlight light control ECU sub-assembly socket in the direction indicated by the arrow in the illustration and disconnect the headlight light control ECU sub-assembly socket.



    B312197E01
  1. Release the set spring as indicated by the arrow in the order shown in the illustration.

  1. Remove the discharge headlight bulb.

    NOTICE:
    Do not touch the bulb glass.



3. REMOVE HEADLIGHT LIGHT CONTROL ECU SUB-ASSEMBLY


    B312198
  1. Remove the 4 screws.



    B312199
  1. Disconnect the connector to remove the headlight light control ECU sub-assembly.



4. REMOVE HEADLIGHT GASKET


    B312200
  1. Remove the headlight gasket.

    NOTICE:
    After the headlight gasket is removed, be sure to replace it with a new one. Failure to do this may cause water ingress.