STEERING LOCK SYSTEM > SYSTEM DESCRIPTION |
| UNLOCK OPERATION CONDITIONS FOR STEERING LOCK |
When any of the following condition are met, the unlock operation is performed:
When any of the following conditions are met, key verification is performed.
| LOCK OPERATION CONDITIONS FOR STEERING LOCK |
When all of the following conditions are met and the certification ECU (smart key ECU assembly) has been verified, the lock operation is performed.
The engine switch is off.
The shift lever is in P*1.
Any door is closed and then opened or a door lock operation (entry door lock, wireless door lock or key-linked lock operation (w/ key-linked switch)*2) is performed.
| INDICATOR FUNCTION |
The entry key indicator blinks in yellow indicating a malfunction is present when one of the following occurs: 1) A vehicle speed information malfunction (vehicle speed mismatch) is detected, 2) a malfunction which may result in the steering lock not operating correctly is detected (however, the steering lock operates properly), or 3) a malfunction in the IG control circuit (hold circuit) is detected. If a malfunction which results in the indicator blinking in yellow occurs, the engine cannot be started once it is turned off.
| STEERING LOCK ACTUATOR ASSEMBLY (STEERING LOCK ECU) DESCRIPTION |
The steering lock ECU is built into the steering lock actuator assembly of the steering column assembly.
The steering lock actuator assembly (steering lock ECU) is not connected to the CAN communication system. However, the steering lock actuator assembly (steering lock ECU) is connected to the certification ECU (smart key ECU assembly) via LIN communication and communicates with other components via CAN communication through the certification ECU (smart key ECU assembly).