Home › Vehicle Exterior › DOOR / HATCH › LUGGAGE COMPARTMENT DOOR OPENER SYSTEM

LUGGAGE COMPARTMENT DOOR OPENER SYSTEM > TERMINALS OF ECU

for Preparation Click here



CHECK MAIN BODY ECU (NETWORK GATEWAY ECU)

B311513E04


Text in Illustration 
*1
Instrument Panel Junction Block Assembly
*2
Main Body ECU (Network Gateway ECU)
  1. Remove the main body ECU (network gateway ECU) from the instrument panel junction block assembly.

  2. Disconnect the D5* and D6 main body ECU (network gateway ECU) connectors.

  3. Measure the resistance and voltage according to the value(s) in the table below.

    Tester Connection
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    D5-27 - Body ground*
    G - Body ground
    Luggage door opening cancel switch signal input
    Luggage door opening cancel switch assembly off
    10 kΩ or higher
    Luggage door opening cancel switch assembly on
    Below 1 Ω
    D6-16 (TSW) - Body ground
    L - Body ground
    Luggage door opening switch signal input
    Luggage door opening switch assembly off
    10 kΩ or higher
    Luggage door opening switch assembly on
    Below 1 Ω
    If the result is not as specified, there may be a malfunction on the wire harness side.

  4. Reconnect the D5* and D6 main body ECU (network gateway ECU) connectors.

  5. Install the main body ECU (network gateway ECU) to the instrument panel junction block assembly.

  6. Measure the voltage according to the value(s) in the table below.

    Tester Connection
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    D5-27 - Body ground*
    G - Body ground
    Luggage compartment door lock motor drive output
    Ignition switch ON
    Luggage door opening cancel switch on
    Below 1 V
    D6-16 (TSW) - Body ground
    L - Body ground
    Luggage compartment door lock motor drive output
    Ignition switch ON
    Luggage door opening switch on
    Below 1 V
    3B-6 - Body ground
    G - Body ground
    Luggage compartment door lock motor drive output
    Ignition switch ON
    Luggage door opening switch on
    11 to 14 V
    If the result is not as specified, the main body ECU (network gateway ECU) or instrument panel junction block assembly may have a malfunction.

  1. *: w/ Side Marker Light