Home › Vehicle Exterior › DOOR / HATCH › LUGGAGE COMPARTMENT DOOR OPENER OUTER SWITCH

LUGGAGE COMPARTMENT DOOR OPENER OUTER SWITCH > INSPECTION

for Preparation Click here



1. INSPECT BACK DOOR OPENER SWITCH ASSEMBLY


    B240807E01
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    1 - 2
    Back door opener switch not pushed
    10 kΩ or higher
    1 - 2
    Back door opener switch pushed
    Below 1 Ω

    Text in Illustration 
    *a
    Component without harness connected
    (Back Door Opener Switch Assembly)
    If the result is not specified, replace the back door opener switch assembly.