RELAY > ON-VEHICLE INSPECTION |
| 1. INSPECT H-LP RELAY |
![]() |
Remove the H-LP relay from the engine room relay block.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 3 - 5 | Voltage is not applied between terminals 1 and 2 | 10 kΩ or higher |
| 3 - 5 | Voltage is applied between terminals 1 and 2 | Below 1 Ω |
| *a | Component without harness connected (H-LP Relay) |
| 2. INSPECT DIM RELAY |
![]() |
Remove the DIM relay from the engine room relay block.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 3 - 5 | Voltage is not applied between terminals 1 and 2 | 10 kΩ or higher |
| 3 - 5 | Voltage is applied between terminals 1 and 2 | Below 1 Ω |
| *a | Component without harness connected (DIM Relay) |
| 3. INSPECT RR FOG RELAY |
![]() |
Remove the RR FOG relay from the engine room relay block.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 3 - 5 | Voltage is not applied between terminals 1 and 2 | 10 kΩ or higher |
| 3 - 5 | Voltage is applied between terminals 1 and 2 | Below 1 Ω |
| *a | Component without harness connected (RR FOG Relay) |
| 4. INSPECT DRL RELAY |
![]() |
Remove the DRL relay from the engine room relay block.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 3 - 4 | Battery voltage not applied | Below 1 Ω |
| 3 - 4 | Battery voltage applied to terminals 1 and 2 | 10 kΩ or higher |
| 3 - 5 | Battery voltage not applied | 10 kΩ or higher |
| 3 - 5 | Battery voltage applied to terminals 1 and 2 | Below 1 Ω |
| *a | Component without harness connected (DRL Relay) |