Home › Vehicle Exterior › LIGHTING (EXT) › HEIGHT CONTROL SENSOR

HEIGHT CONTROL SENSOR > INSPECTION

for Preparation Click here



1. INSPECT REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY LH


    B309152E01
  1. Connect 3 dry cell batteries (1.5 V) in series.

    NOTICE:
    Do not use rechargeable batteries as they may not output a voltage of 1.5 V.

  1. Connect the positive (+) lead from the batteries to terminal 3 and the negative (-) lead from the batteries to terminal 1 (GND).

  1. Measure the voltage between terminals 2 (OUT) and 1 (GND) while slowly moving the link up and down.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    2 (OUT) - 1 (GND)
    +45° (High)
    4.5 V
    2 (OUT) - 1 (GND)
    -15° (Normal)
    2.5 V
    2 (OUT) - 1 (GND)
    -45° (Low)
    0.5 V

    Text in Illustration 
    *a
    Component without harness connected
    (Rear Height Control Sensor Sub-assembly LH)
    *b
    +45°
    *c
    -15°
    *d
    -45°
    *e
    Reference line
    If the result is not as specified, replace the rear height control sensor sub-assembly LH.