Home › Vehicle Interior › SEAT › FRONT SEAT ASSEMBLY

FRONT SEAT ASSEMBLY > DISASSEMBLY

for Preparation Click here


CAUTION:
Wear protective gloves. Sharp areas on the parts may injure your hands.

HINT:
  1. Use the same procedure for RHD and LHD vehicles.
  2. The procedure listed below is for LHD vehicles.
  3. Use the same procedure for the RH and LH sides.
  4. The procedure listed below is for the LH side.



1. REMOVE RECLINING ADJUSTER RELEASE HANDLE


    B299961E01
  1. Using a screwdriver with its tip wrapped with protective tape, disengage the claw and remove the reclining adjuster release handle.
    Text in Illustration 
    *1
    Protective Tape



2. REMOVE VERTICAL ADJUSTING HANDLE (for Driver Side)


    B299962
  1. Remove the screw and vertical adjusting handle.



3. REMOVE SEAT ADJUSTER COVER CAP


    B348034E01
  1. Using a screwdriver with its tip wrapped with protective tape, disengage the 3 claws to remove the seat adjuster cover cap.
    Text in Illustration 
    *1
    Protective Tape



4. REMOVE FRONT SEAT CUSHION SHIELD


    B311900
  1. Remove the 2 screws.

  1. Disengage the 4 claws, 5 guides and clip to remove the front seat cushion shield.



5. REMOVE FRONT SEAT INNER CUSHION SHIELD


    B299964
  1. Disengage the 2 claws and 4 guides to remove the front seat inner cushion shield.



6. REMOVE FRONT SEAT INNER BELT ASSEMBLY (for Driver Side)


    B299965
  1. Disconnect the rubber band of the separate type front seatback cover.



    B299966
  1. Disengage the claw and each clamp under the front seat assembly.



    B299967
  1. Disengage each clamp.

  1. Remove the nut, washer and front seat inner belt assembly.



7. REMOVE FRONT SEAT INNER BELT ASSEMBLY (for Front Passenger Side)
  1. Disconnect the occupant classification sensor connector.



    B311976
  1. Disengage the claw and each clamp under the front seat assembly.



      B311399
    1. Remove the nut, washer and front seat inner belt assembly.



8. REMOVE SEAT LOCK BAND ASSEMBLY (for Fold Down Seat Type)


    B348037
  1. Remove the screw and seat lock band assembly.



9. REMOVE SEAT TRACK CONTROL CABLE ASSEMBLY (for Walk in Seat Type)


    B348035
  1. Disengage the 2 claws to disconnect the seat track control cable assembly.

  1. Remove the seat track control cable assembly as shown in the illustration.

    NOTICE:
    Be careful not to damage the seat track control cable assembly.



10. REMOVE SEAT TRACK CABLE BRACKET (for Walk in Seat Type)


    B348036
  1. Remove the washer and seat track cable bracket.



11. REMOVE SEPARATE TYPE FRONT SEATBACK ASSEMBLY


    B299970
  1. Disengage the 2 hooks.



    B299965
  1. Disconnect the rubber band of the separate type front seatback cover.



    B281106
  1. Disconnect the front seat heater connector and disengage the clamp. (w/ Seat Heater System)



    B280208
  1. Disengage the fastener and separate the front seat airbag assembly wire harness.



    B311905
  1. Disengage the claw and 4 clamps to separate the front seat airbag assembly wire harness.



    B348038
  1. Remove the washer (for Fold Down Seat Type).



    B311908
  1. Using a T40 "TORX" socket wrench, remove the 4 bolts, separate type front seatback assembly and No. 2 front seat travel link.



12. REMOVE SEPARATE TYPE FRONT SEATBACK COVER WITH PAD


    B299972
  1. Remove the 5 hog rings.



    B299973
  1. Open the 2 fasteners.

  1. Turn back the separate type front seatback cover.



    B348039
  1. Remove the 2 hog rings.



    B299974
  1. Disengage the 2 hooks.



    B299977
  1. Remove the nut and the 3 brackets.



    B299975
  1. Disengage the 4 claws and remove the 2 front seat headrest supports.

  1. Remove the separate type front seatback cover with pad from separate type front seatback spring assembly.



13. REMOVE FRONT SEAT AIRBAG ASSEMBLY


    B311964
  1. Disengage the 2 clamps.



    B311965
  1. Remove the 2 nuts and the front seat airbag assembly.

    CAUTION:
    1. The nuts must not be reused.
    2. Make sure that the separate type front seatback spring assembly is not deformed. If it is, replace it with a new one.



14. REMOVE SEPARATE TYPE FRONT SEATBACK COVER


    B299976
  1. Remove the 14 hog rings and separate type front seatback cover from the separate type front seatback pad.

  1. Remove the 7 front seatback cover wires from the separate type front seatback cover.



15. REMOVE NO. 2 FRONT SEATBACK HOOK


    B348027
  1. Disengage the 2 claws to remove the 2 No. 2 front seatback hooks from the separate type front seatback spring assembly.



16. REMOVE FRONT SEATBACK SPRING SUB-ASSEMBLY


    B348028
  1. Disengage the 2 claws and 2 hooks to remove the front seatback spring sub-assembly from the separate type front seatback spring assembly.



17. REMOVE NO. 1 FRONT SEATBACK HOOK
  1. Remove the 2 No. 1 front seatback hooks from the front seatback spring sub-assembly.



18. REMOVE SEPARATE TYPE FRONT SEAT CUSHION COVER WITH PAD
  1. Disconnect the occupant detection sensor connector. (for Front Passenger side)



    B311906
  1. Disengage the claw and 3 clamps to separate the front seat heater wire harness. (w/ Seat Heater System)



  1. Disengage each hook and remove the separate type front seat cushion cover with pad from separate type front seat cushion spring assembly. (for Driver Side)


    B299978



  1. Disengage each hook and remove the separate type front seat cushion cover with pad from separate type front seat cushion spring assembly. (for Front Passenger Side)


    B311409



19. REMOVE SEPARATE TYPE FRONT SEAT CUSHION COVER


    B299979
  1. Remove the 2 hog rings.



    B299980
  1. Remove the 12 hog rings and the separate type front seat cushion cover from the separate type front seat cushion pad.

  1. Remove the 4 front seat cushion cover wires from the separate type front seat cushion cover.



20. REMOVE FRONT SEAT LOWER CUSHION SHIELD LH (for Driver Side)


    B299982
  1. Remove the screw.

  1. Disengage the hook.

  1. Disengage the clip and remove the front seat lower cushion shield LH.



21. REMOVE FRONT SEAT LOWER CUSHION SHIELD RH (for Driver Side)

HINT:
Use the same procedure as for the LH side.



22. REMOVE LH SEAT FRONT SEAT CUSHION EDGE PROTECTOR LH


    B281081
  1. Remove the screw.

  1. Disengage the 3 claws to remove the LH seat front seat cushion edge protector LH.



23. REMOVE LH SEAT FRONT SEAT CUSHION EDGE PROTECTOR RH

HINT:
Use the same procedure as for the LH side.



24. REMOVE SEAT TRACK ADJUSTING HANDLE


    B299985
  1. Using a screwdriver, disengage the 2 springs to remove the seat track adjusting handle from separate type front seat cushion spring assembly.



25. REMOVE NO. 1 FRONT SEAT CUSHION PROTECTOR (for Driver Side)


    B348040
  1. Disengage the claw to remove the No. 1 front seat cushion protector from the separate type front seat cushion spring assembly.



26. REMOVE NO. 2 FRONT SEAT CUSHION PROTECTOR (w/o Seat Heater System)


    B348041
  1. Disengage the claw to remove the No. 2 front seat cushion protector from the separate type front seat cushion spring assembly.



27. REMOVE FRONT SEAT CUSHION SPRING


    B348029
  1. Disengage the 8 hooks to remove the front seat cushion spring from the separate type front seat cushion spring assembly.