Home › Vehicle Interior › SEAT BELT › OCCUPANT DETECTION SENSOR

OCCUPANT DETECTION SENSOR > INSTALLATION

for Preparation Click here


HINT:
  1. Use the same procedure for the front passenger side of RHD and LHD vehicles.
  2. The procedures listed below are for the front passenger side of an LHD vehicle.



1. INSTALL SEPARATE TYPE FRONT SEAT CUSHION PAD (OCCUPANT DETECTION SENSOR)


    B299986E01
  1. Using hog ring pliers, install the separate type front seat cushion pad to the separate type front seat cushion cover with 12 new hog rings.

    NOTICE:
    1. Be careful not to damage the separate type front seat cushion cover.
    2. When installing the hog rings, take care to minimize wrinkles as much as possible.

    Text in Illustration 
    *1
    Hog Ring
    *2
    Hog Ring Pliers



    B279525E01
  1. Using hog ring pliers, install 2 new hog rings.

    NOTICE:
    1. Be careful not to damage the separate type front seat cushion cover.
    2. When installing the hog rings, take care to minimize wrinkles as much as possible.

    Text in Illustration 
    *1
    Hog Ring
    *2
    Hog Ring Pliers



2. INSTALL SEPARATE TYPE FRONT SEAT CUSHION COVER WITH PAD

HINT:
Use the same procedure as for the driver seat (Click here).