Home › Vehicle Interior › HEATING / AIR CONDITIONING › SOLAR SENSOR

SOLAR SENSOR > REMOVAL

for Preparation Click here



1. PRECAUTION

NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work (Click here).



2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
The power window system utilizes a mechanism in which the door glass moves down slightly when the door is opened, and in which the glass moves up when the door closed in order to prevent the door molding from being damaged. When the negative (-) battery terminal needs to be disconnected for servicing, fully open the driver and passenger door glasses in advance.



3. SEPARATE NO. 1 DEFROSTER NOZZLE GARNISH


    E250738E01
  1. Using a moulding remover, separate the 3 claws as shown in the illustration.
    Text in Illustration 
    *1
    Moulding Remover



4. REMOVE AUTOMATIC LIGHT CONTROL SENSOR


    E246464
  1. Disconnect the connector.

  1. Disengage the 2 claws and remove the automatic light control sensor.