Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › VSC OFF SWITCH

VSC OFF SWITCH > INSTALLATION

for Preparation Click here



1. INSTALL PATTERN SELECT SWITCH ASSEMBLY
  1. Install the 2 screws and the pattern select switch assembly to the shifting hole cover sub-assembly.

  1. Connect the pattern select switch assembly connector clamp. (for Automatic Transmission)

  1. Connect the pattern select switch assembly connector.



2. INSTALL SHIFTING HOLE COVER SUB-ASSEMBLY (for Manual Transmission)
  1. Engage the claw.

  1. Install the shifting hole cover sub-assembly with the 2 screws.



3. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY (for Manual Transmission)


    B317120E01
  1. Turn the knob clockwise to install the shift lever knob sub-assembly.
    Text in Illustration 
    *1
    Pull collar

    NOTICE:
    1. Tighten the shift lever knob until the tightening on the shift lever knob stiffens.
    2. Check that the transmission moves into reverse when the pull collar is pulled.



4. INSTALL SHIFTING HOLE COVER SUB-ASSEMBLY (for Automatic Transmission)
  1. Engage the claw.

  1. Install the shifting hole cover sub-assembly with the 2 screws.



5. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY (for Automatic Transmission)


    B315239
  1. Turn the knob clockwise to install the shift lever knob sub-assembly.

    NOTICE:
    1. Tighten the shift lever knob until the tightening on the shift lever knob stiffens.

    1. B321464E01
      Face the groove on the shift lever knob toward the rear of the vehicle.
      Text in Illustration 
      *1
      Groove