Home › General › SPECIFICATIONS › CLUTCH

CLUTCH > SERVICE DATA



Clutch Pedal 
Pedal play
4.0 (0.158 in.)
Pedal stroke
(Reference)
110 to 115 mm (4.331 to 4.528 in.)

Clutch Unit 
Clutch disc rivet depth
Minimum
0.3 mm (0.0118 in.)
Clutch disc runout
Maximum
0.8 mm (0.0315 in.)
Clutch cover diaphragm spring wear
Maximum depth
0.5 mm (0.0197 in.)
Maximum width
6.0 mm (0.236 in.)
Flywheel runout
Maximum
0.1 mm (0.00394 in.)
Clutch cover diaphragm spring tip non-alignment
Maximum
0.5 mm (0.0197 in.)
Flywheel bearing depth from flywheel edge
Standard
0 to 0.4 mm (0 to 0.0158 in.)

Clutch Pedal Switch 
Clutch start switch assembly
Standard resistance
1 - 2
ON (Pushed in)
Below 1 Ω
OFF (Released)
10 kΩ or higher
Clutch switch assembly
Standard resistance
1 - 2
ON (Pushed in)
Below 1 Ω
OFF (Released)
10 kΩ or higher