Home › General › SPECIFICATIONS › FA20 COOLING

FA20 COOLING > SERVICE DATA



Radiator Cap
Pumping speed:
1 pump per second
Standard valve (for brand-new cap):
93 to 123 kPa (0.95 to 1.25 kgf*cm2, 14 to 18 psi)
Minimum standard valve (after suing cap):
83 kPa (0.85 kgf*cm2, 12 psi)
Thermostat (for Engine Coolant)
Valve opening temperature:
86 to 90°C (187 to 194°F)
Valve lift:
8.0 mm (0.315 in.) or more at 95°C (203°F)
Thermostat (for Automatic Transmission)
Valve opening temperature:
48 to 52°C (118 to 126°F)
Valve lift:
6.0 mm (0.236 in.) or more at 63°C (145°F)
Cooling fan motor
Standard current:
7.4 to 11.4 A at 20°C (68°F)
(when the battery is connected to the fan motor connector)
No. 2 cooling fan motor
(w/ Air Conditioning System)
Standard current:
7.4 to 11.4 A at 20°C (68°F)
(when the battery is connected to the fan motor connector)
Fan No. 1 relay
Standard resistance (3 - 5): 10 kΩ or higher
(Battery voltage is not applied between terminals 1 and 2)
Standard resistance (3 - 5): Below 1 Ω
(Battery voltage is applied between terminals 1 and 2)
Fan No. 2 relay
(w/ Air Conditioning System)
Standard resistance (3 - 4): Below 1 Ω
(Battery voltage is not applied between terminals 1 and 2)
Standard resistance (3 - 5): 10 kΩ or higher
(Battery voltage is not applied between terminals 1 and 2)
Standard resistance (3 - 4): 10 kΩ or higher
(Battery voltage is applied between terminals 1 and 2)
Standard resistance (3 - 5): Below 1 Ω
( Battery voltage is applied between terminals 1 and 2)
Fan No. 3 relay
(w/ Air Conditioning System)
Standard resistance (3 - 5): 10 kΩ or higher
(Battery voltage is not applied between terminals 1 and 2)
Standard resistance (3 - 5): Below 1 Ω
((Battery voltage is not applied between terminals 1 and 2)