Home › Vehicle Exterior › LIGHTING (EXT) › TURN SIGNAL FLASHER ASSEMBLY

TURN SIGNAL FLASHER ASSEMBLY > INSPECTION

for Preparation Click here



1. INSPECT TURN SIGNAL FLASHER ASSEMBLY


    B215625E02
  1. Disconnect the D61 turn signal flasher assembly connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    D61-4 (+B) - Body ground
    Ignition switch off
    Below 1 V
    Ignition switch ON
    11 to 14 V
    D61-1 (IG) - Body ground
    Always
    11 to 14 V

    Text in Illustration 
    *a
    Front view of wire harness connector
    (to Turn Signal Flasher Assembly)
    If the result is not as specified, repair or replace the wire harness or connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    D61-7 (GND) - Body ground
    Always
    Below 1 Ω

    If the result is not as specified, repair or replace the wire harness or connector.



    E162022E09
  1. Reconnect the D61 turn signal flasher assembly connector.

  1. Measure the voltage according to the valve(s) in the table below.

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    D61-6 (ER) - Body ground
    Turn signal switch in RH position OFF to ON
    9 V or higher to below 1 V
    D61-5 (EL) - Body ground
    Turn signal switch in LH position OFF to ON
    9 V or higher to below 1 V
    D61-8 (EHW) - Body ground
    Hazard warning switch OFF to ON
    9 V or higher to below 1 V
    D61-2 (LR) - Body ground
    Turn signal switch in RH position OFF to ON
    Below 1 V to 9 V (60 to 120 times per minute)
    D61-3 (LL) - Body ground
    Turn signal switch in LH position OFF to ON
    Below 1 V to 9 V (60 to 120 times per minute)
    D61-2 (LR) - Body ground
    Hazard warning switch OFF to ON
    Below 1 V to 9 V (60 to 120 times per minute)
    D61-3 (LL) - Body ground
    Hazard warning switch OFF to ON
    Below 1 V to 9 V (60 to 120 times per minute)

    Text in Illustration 
    *a
    Component with harness connected
    (Turn Signal Flasher Assembly)
    If the result is not as specified, the turn signal flasher assembly may have a malfunction.