AUDIO AND VISUAL SYSTEM > Sound Signal Circuit between Radio Receiver and Stereo Jack Adapter |

| 1.CHECK HARNESS AND CONNECTOR (RADIO RECEIVER ASSEMBLY - NO. 1 STEREO JACK ADAPTER ASSEMBLY) |
Disconnect the No. 1 stereo jack adapter assembly and radio receiver assembly connectors.
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| a1-9 (AUX I) - D12-25 (AUXI) | Always | Below 1 Ω |
| a1-6 (AR I) - D12-26 (ARI) | Always | Below 1 Ω |
| a1-7 (AL I) - D12-28 (ALI) | Always | Below 1 Ω |
| a1-8 (ASGN) - D12-27 (ASGN) | Always | Below 1 Ω |
| a1-10 (AGND) - D12-11 (AGND) | Always | Below 1 Ω |
| a1-9 (AUX I) - Body ground | Always | 10 kΩ or higher |
| a1-6 (AR I) - Body ground | Always | 10 kΩ or higher |
| a1-7 (AL I) - Body ground | Always | 10 kΩ or higher |
| a1-8 (ASGN) - Body ground | Always | 10 kΩ or higher |
| a1-10 (AGND) - Body ground | Always | 10 kΩ or higher |
| *a | Front view of wire harness connector (to Radio Receiver Assembly) |
| *b | Front view of wire harness connector (to No. 1 Stereo Jack Adapter Assembly) |
|
| ||||
| OK | ||
| ||