Fuel pressure
| 350 to 500 kPa (4.0 to 5.0 kgf/cm2, 51 to 73 psi)
|
Fuel pressure : at fuel pressure remains for 5 minutes after engine has stopped
| 147 kPa (1.5 kgf/cm2, 21 psi) or more
|
Fuel pressure (for high pressure) : at engine warm up and idle
| 3000 to 5000 kPa (30.6 to 51.0 kgf/cm2, 435 to 725 psi)
|
Fuel injector (for port injection)
|
Resistance
| at 20°C (68°F)
| 12 Ω
|
Injection volume
| 84 to 103 cc(5.1 to 6.3 cu.in.) per 15 seconds
|
Difference between each injector
| 19 cc(1.2 cu.in.) or less
|
Fuel drop
| 1 drop or less per 22 minutes
|
Fuel Injector (for direct injection)
|
Resistance
| at 20°C (68°F)
| 1.9 Ω
|
Fuel pressure sensor
|
voltage
| Terminal 3 (VOUT1) and 2 (GND) : Apply 5 V between terminals 4 (VCC) and 2 (GND)
| Approximately 0.5 V
|
Fuel pump
|
Resistance
| at 20°C (68°F)
| 0.2 to 3.0 Ω
|
Fuel pump (for high pressure)
|
Resistance
| at 20°C (68°F)
| 1.19 to 1.39 Ω
|
Fuel sender gauge assembly (Main)
|
Resistance
| Float Level F
| 6.5 to 8.5 Ω
|
Float Level E
| 168 to 172 Ω
|
Fuel sender gauge assembly (Sub)
|
Resistance
| Float Level F
| 5.5 to 9.5 Ω
|
Float Level E
| 236 to 244 Ω
|